Tandriem

Tandriem aandrijving: Aandrijfriem, V-snaar, Belt.


How to select the right size drive belt.

1 - Check the outside of the old belt for its size digits. These digits may be placed together (5355M15), or may have dashes or slashes (535-5M/15), or may have the first 5 digits only(535-5M or 5M535). Other variations are also possible depending upon the belt manufacturer.

2 - Check the Belts Listed By Scooter Make And Model chart to find your belt size.

3 - If the drive belt does not have its size printed on it here is how to figure out its dimensions:
a) Measure the length of the belts loop
b) Measure the distance from peak to peak of two adjacent belt teeth
c) Measure the width of belt

4 - If the drive belt is missing or lost wrap a small piece of insulated electrical wire firmly around the scooters drive sprockets positioned in place where the drive belt should be. Then mark the wires with a pen where they intersect. The length between the pen marks indicates the approximate belt length that is needed. The sprockets peak to peak teeth distance and the sprockets teeth width measurements also need to be measured.

Drive Belt Sizing Legend

Length of belts loop in mm
(3 numbers)

Peak to peak teeth distance in mm
(1 number with "M" on the end)

Width in mm
(2 numbers)

447

3M

12


Drive Belt Teeth Spacing:
3mm teeth: The distance from peak to peak of two adjacent belt teeth is 3mm or slightly under 1/8" apart.
5mm teeth: The distance from peak to peak of two adjacent belt teeth is 5mm or slightly over 3/16" apart.

Inches to Millimeters Conversion Formula:
Inches x 25.4 = Millimeters
The conversion calculator located below will calculate this formula.
(conversion example: 24" x 25.4 = 609.59mm (a 610mm belt match)

Tandriem aandrijfriemen afmeting:

View belts listed by scooter make and model.